Setting The Cut Mode; Perform Multiple Cuttings (Copy Function) - MIMAKI CJV150-75 Operation Manual

Chapter 4 Cutting Funcion

Setting the CUT MODE

This is to set the cutting quality.
There are the following three type for cut mode.
Setting
Standard This is a regular cutting mode.
This is used to perform cutting in a short time (it
High speed
is not appropriate for the heavy media).
This is a cutting mode used to give priority to
High quality
cutting quality.
• Select "QUALITY" in any of the following cases:
• Characters whose sizes are 10 mm or less are to
be cut
• Picture patterns or characters that have many
sharp corners are to be cut
• Minute cutting is to be performed
However, the edges of finished patterns may be
rugged if the data sent from the host computer is
too complicated. In such a case, select "HIGHspd"
for smooth finish.
• With "QUALITY", the cutting speed is limited to 20
cm/s.
1
Press the
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
and press the
3
Press
and press the
• Set value : Standard, high speed, High quality
4
Press the
end the setting.
4-10
Description
(MENU) (>>)
to select the "CUT MODE",
key.
to select the setting value,
key.
key several times to
perform multiple Cut-
tings (Copy function)
This function performs cutting for the received data on two
or more sheets.(Maximum 999 cuttings)
Copy
interval
• You can perform multiple cuttings by specifying data saved in
the receiving buffer of this device.
• The receiving buffer can save only one data.
• When a new data is received, the data that has been saved is
overwritten by it.
(You cannot perform multiple cuttings by specifying the data
that was received before.)
1
Press the
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press to select the "COPY", and
press the
3
Press to select the number of
cutting (1 to 999), and press the
key.
4
Press to select the interval of
figures to be cut (0 to 30mm), and press
the key.
• If the multiple sheet cutting is executed
immediately after cutting in the remote mode,
cutting (plotting) will be overlapped. To avoid this
trouble, be sure to set the new origin.
• While the machine is executing the multiple sheet
cutting, it ignores data sent from the computer.
• To send two or more pieces of data from the
computer to the machine, the data has to be sent
while providing an interval of 5 seconds or more
between any two pieces of data. If two pieces of
data are sent from the computer to the machine
within 5 seconds, the two pieces of data will be
subjected to the multiple sheet cutting. The
machine performs cutting for divided cutting data
by the specified number of sheets without dividing
the data. If any error is displayed, refer to "Error
messages" ( P.6-8).
• If there is the origin renewal command in cutting
data, you cannot perform copy function.
• When you use FineCut, the default value of Origin
Renewal is "ON". If you perform [No. COPIES],
uncheck the checkbox. (Refer to FineCut
OPERATION MANUAL Chapter5 "Setting Head
Position after Plotting")
The origin at
executing the multiple
sheet cutting. (Manual
The origin at
terminating the
multiple sheet cutting
(MENU) (>>)
key.