Setting Of Detecting The Registration Marks - MIMAKI CJV150-75 Operation Manual

Chapter 4 Cutting Funcion
Setting of Detecting the Registration
Marks
When you want to cut the data with registration marks,
you must set the following without fail.
1
Press the
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
DETECT", and press the
3
Press
and press the
• Refer to "The setting items of detecting the
registration marks"(
4
Press
and press the
• Set value : Standard, high speed, High quality
5
Press the
end the setting.
• You can set the register mark detection without
pressing [FUNC1] (MENU) from LOCAL.
(1) Press the [SEL] key in LOCAL to display
"TEST CUT".
(2) Press [FUNC2] (TEST CUT)
(3) Press the [ENTER] key
• After this, go to step 3 of "Setting of Detecting the
Registration Marks".
4-6
(MENU) (>>)
to select the "MARK
key.
to select the setting item,
key.
P.4-6).
to select the setting value,
key.
key several times to
The setting items of detecting the
registration marks
There are the following seven setting items for registration
mark detection.
(1) MARK DETECT
Setting
The registration marks can be detected if this is
ON/OFF
set to ON.
(2) MARK TYPE
Select either one of the following types of registration
marks.
• Use the copy function of cutting software, in the
case of continuous cut, select the register mark of
Zero margin, and you will be able to place no
margin between the register marks.
By eliminating the margin between the register
marks to cut efficiently, recommend to use register
mark shaped "Zero Margin".
Setting
Type 1
Type 2
Zero margin
(3) MARK SIZE
Set the length of one side of the
registration mark.
Setting
When the printed mark's horizontal and vertical
5 to 40mm lengths differ from each other, set the same
value as the shorter length.
Description
Description
Length of
one side
Description