How To Install A Ballpoint Pen - MIMAKI CJV150-75 Operation Manual

Chapter 2 Basic Operation
How to install the cutter holder
• Install the cutter holder to the tool holder of the
carriage.Be sure to insert the cutter holder all the
way in the tool holder.
1
Press the
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
REPLACE", and press the
3
Press the
• The cutter unit moves to the left end of the
machine.
4
Rotate the knob to loosen the holder
presser.
Holder presser
Knob
5
Insert the cutter holder into the tool holder.
• Push the brim of the cutter holder against the tool
holder.
• Press the brim of the cutter holder with the l
holder presser.
Holder presser
6
Fix the cutter holder.
• Turn the knob of the tool holder clockwise, and
surely fix it.
• Fix the cutter holder firmly. If not, accurate and
high-quality cutting will not be achieved.
2-24
(MENU) (>>)
to select "TOOL
key.
key.
Brim
Knob

How to Install a Ballpoint Pen

• When you want to use a commercially available
ballpoint pen, you must use the pen of 8mm to
9mm in diameter. Image quality may depend on
the pen. (Recommended ballpoint pen: the one
available from Pentel Co., Ltd. with the product
No.: K105-A, K105-GA)
• Regarding such ballpoint pens as shown below,
the pen inclines to touch the cover when held by
the pen adapter (the pen that the pen holder girth
of which may vary, the pen that the pen holder of
which has umbo and differences)
Uneven gauge
1
Put the cap on the pen adapter.
• Use the cap to adjust the pen height.
2
Insert the pen into the pen adapter.
• Insert the pen until the tip of the pen reaches the
cap.
3
Fix the tip of the pen.
• Tighten the fixing screw clockwise.
• Be careful not to over-tighten the fixing screw for
the pen adapter. If tightened too much, the ball-
point pen may crack.
4
Remove the cap.
5
Press the
(MENU)
key in LOCAL.
• Cuttibg MENU will be displayed.
With steps or bumps
Pen
Pen adapter
Fixing screw
Cap
(>>)