Setting The Cutting Conditions; About The Cut Conditions; Select The Tool Condition - MIMAKI CJV150-75 Operation Manual

Chapter 2 Basic Operation
Setting the cutting
conditions
You can register the cutting speed and the pressure
depending on the sheet or the tool type to be used.
(Cut condition)

About the Cut Conditions

Items you can set here
Tool You can select the cutting condition No.(1 to 7) or
condition plotting condition (PEN).
Cut speed Setting of the speed of cutting.
Cut press Setting of the pressure required for cutting. (g)
Setting of the distance from the center of the cutter
*1
Offset
holder to the cutter blade.
Setting of enabling (ON)/disabling (OFF) the half-
*2
Half cut
cut function.
Half cut
Setting of the pressure of left part. (g)
press
H-leng Setting of the length to be left (not to be cut). (mm)
C-leng Setting of the length to be cut. (mm)
*1. You cannot set this when "PEN" is selected in the tool condition,
*2. The three items in the lower level are available when the half-cut is
set to ON.
About Selecting Cutting Condition
1
Press the
LOCAL.
2
Press
• The three items shown in the following screen are
not displayed unless the half-cut is set to ON.
2-26
key to display "TOOL" in
to display the cut condition.
About Half Cutting
You can cut on the dotted line, not to cut sheet out.
(Half cut)
When you set half cut to valid (ON), you can use the half
cut function.
Sheet
Set the length Set the length
to be left to be cut.
(not to be cut).
• The illustration above is the image. The shape of
cut surface differs depending on the cutting
conditions.

Select the tool condition

Before cutting (plotting), select the tool condition
depending on the sheet and the tool type to be used.
1
Press the
the "TOOL" menu.
2
Press the (TOOL).
3
Press the
4
Press to select a tool condition
to be used.
• Each time you press [][], the tool condition is
switched as follows.
CUT1 ～ 3
CUT4 ～ 7
5
Cutting. ( P.2-22)
Cutter
Set the
cutting
pressure
key in LOCAL to display
key.
PEN