Media Sensor; Carriage; Cutter Blade And Slot For Cutting; Capping Station - MIMAKI CJV150-75 Operation Manual

Media sensor

The media sensor detects the presence of the media and
the media length.
This machine has one media sensor on the platen (in the
rear).

Media sensor

• When setting a media, be sure to cover the media
sensors located on the rear of the platen. The
media cannot be detected unless it is placed over
the sensor.

Carriage

The carriage consists of the printer unit and the cutter
unit.
Printer Unit
Cutter Unit
Cutter unit
Printer unit

Cutter blade and slot for cutting

The carriage is provided with a cutter unit for cutting off
the media that has been printed on.
The cutter cuts off the sheet of media along the slot for
cutting on the platen.
slot for cutting

Capping station

The capping station consists of the ink caps, the wiper for
cleaning the heads, etc.
The ink caps prevent the nozzles in the ink heads from
drying up.
The wiper cleans the nozzles in the heads.
The wiper is consumable.If the wiper is deformed or the
media is stained, replace the wiper with a new one.
• Be sure to wear the attached goggles in cleaning
within the capping station to protect your eyes
against ink. Otherwise, you may get ink in your
eyes.

Pinch Rollers and Grit Rollers

This machine retains the media with the pinch rollers and
the grit rollers.
• Keep the pinch rollers lifted up when this machine
is not in use. If the pinch rollers are left lowered
for an extended period of time, they can be
deformed and fail to securely retain the media.
Feed roller
Chapter 1 Before Use
Cutter part
Pinch roller
1-7
1
2
2
2
2