** Enter Setup
CODE ID Prefix
Code ID can also be used to identify barcode type. Unlike AIM ID, Code ID is user programmable. For the
information of default Code ID, see the Code ID Table section in Appendix.
Enable CODE ID Prefix
Restore All Default Code IDs
Set Code ID
Code ID can only consist of one or two English letters. To set a Code ID, scan a Set Code ID barcode,
the numeric barcodes corresponding to the hexadecimal value of a desired ID and the Save barcode.
Example: Set the Code ID of Code 128 to "p" (its hexadecimal value is 0x70)
1.
Scan the Enter Setup barcode.
2.
Scan the Set Code 128 Code ID barcode. (See the barcode on the following page )
Scan the numeric barcodes "7" and "0". (See the Digit Barcodes section in Appendix)
3.
4.
Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5.
Scan the Exit Setup barcode.
Exit Setup
Restore All Default Code IDs
** Disable CODE ID Prefix
72