Installing The Device; Plugging The Device Into The Vehicle Connector; Optional) Installed By Extension Cord - MeiTrack TC68S User Manual

Gps tracker

Hide thumbs Also See for TC68S:

Table of Contents

MEITRACK TC68S User Guide

Password: 0000 (default password; you can change it later)

6 Installing the Device

The TC68S is a plug-and-play device without wiring.

After the device is plugged into the vehicle OBD II connector, the device will beep once, and all indicators will blink, which

indicates that the device is installed successfully.

Note: Ensure that the device is firmly connected to the vehicle connector.

The extension cord is an optional accessory. If you purchase this accessory, use this method to install the device.

Installing by extension cord is a better choice on the condition of narrow installation space, weak GPS signal, or for hidden

purpose.

Perform the following operations to install the device:

Stick two small suede Velcro to the labeled device surface and the connected surface of the extension cord.

Plug the male side of the extension cord to the vehicle OBD II connector.

Find a hidden place under the dashboard, and stick the big Velcro to the vehicle.

Attach the device with Velcro to the Velcro of the vehicle.

Note: You can also use other ways such as cable ties to secure the device when there is enough space in the vehicle.

- 13 -

Table of Contents