How To Use; Installing The Sim Card; Charging; Indicator - MeiTrack TC68S User Manual

MEITRACK TC68S User Guide
8 Microphone
10 OBD II Plug

5 How to Use

5.1 Installing the SIM Card

To install the SIM card, perform the following operations:
Open the SIM card cover, insert the card (card chip facing down), and close the card cover.
Note:

Ensure that the SIM card has sufficient balance.

Ensure that the phone card PIN lock has been closed.

Ensure that the SIM card in the device has subscribed the caller ID service if you want to send an SMS.

Power off the device before installing the SIM card.

5.2 Charging

When you use the device for the first time, connect the USB cable to the computer for charging. Ensure that the device is
charged at least three hours. To shorten charging time, power off the device and then charge it.

5.3 Indicator

To start the device, press and hold down the power button for 3s to 5s. Once the device is plugged into the vehicle OBD II
connector, a sound will be made.
GPS Indicator (Blue)
Steady on
Blink (every 0.1s)
Blink (0.1s on and 2.9s off)
Blink (1s on and 2s off)
GSM Indicator (Green)
Steady on
Blink (every 0.1s)
Blink (0.1s on and 2.9s off)
Blink (1s on and 2s off)
Copyright © 2015 Meitrack Group All rights reserved.
dialing when one phone number answers. Meanwhile, the device will send an SMS
with positioning information to the authorized phone number. If the GPRS function
is enabled, the device will send a GPRS message to the server.
Shortly press the button to wake the device up if the device is in sleep mode.
It will run automatically when the listen-in function is used.
Connect to the vehicle OBD II connector. The device is powered by vehicle's
battery.
One button is pressed or one input is activated.
The device is being initialized or the battery power is low.
A GPS signal is received.
No GPS signal is received.
A call is coming in or a call is being made.
The device is being initialized.
A GSM signal is received.
No GSM signal is received.
- 8 -