Action Uri - Yealink SIP-T4X Administration Manual

Variable Value
ANSWER
Reset
ATrans=xxx
BTrans=xxx
CALLEND
Note
The variable value is not applicable to all events. For example, the variable value
"MUTE" is only applicable when the IP phone is during a call.
When authentication is required, you must enter
"p=login&q=login&username=xxx&pwd=yyy&jumpto=URI&" before the variable
"key". xxx refers to the login user name and yyy refers to the login password.
For security reasons, IP phones do not receive and handle the HTTP/HTTPS GET requests
by default. You need to specify the trusted IP address for action URI. When the IP phone
receives a GET request from the specified IP address for the first time, the LCD screen
prompts the message "Allow Remote Control?". You can specify one or more trusted IP
addresses on the IP phone, or configure the IP phone to receive and handle the URI
from any IP address.
Procedure
Specify the trusted IP address for Action URI using the configuration files or locally.
Configuration File
Local
To configure the trusted IP address(es) for Action URI via web user interface:
1. Click on Features->Remote Control.
Answer a call.
Reset a phone.
Perform a semi-attended/attended transfer to xxx.
Perform a blind transfer to xxx.
End a call.
<y0000000000xx>.cfg
Web User Interface
Configuring Advanced Features
Phone Action
Specify the trusted IP
address(es) for sending the
Action URI to the IP phone.
For more information, refer to

Action URI

on page 337.
Specify the trusted IP
address(es) for sending the
Action URI to the IP phone.
Navigate to:
http://<phoneIPAddress>/servl
et?p=features-remotecontrl&q
=load
161