Yealink SIP-T41P Quick Installation Manual

1. Press the key when the phone is idle to obtain the IP address of the phone.
2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,
"http://192.168.0.10" or "192.168.0.10"), and then press the
3. Enter the user name (default: admin) and password (default: admin) in the login page
and click .
Click on ->
You can configure the network settings in the following ways:
: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address.
: If your phone can not contact a DHCP server for any reason, you need to
configure the IP address, subnet mask, gateway address, primary DNS address and
secondary DNS address for the phone manually.
The wrong network settings may result in the inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Click on ->
Register Status: It shows the register status of the current account.
Line Active: You can select Enabled/Disabled to enable/disable the account.
Label: It is shown on the LCD to identify the account.
Display Name: It is shown as Caller ID when placing a call.
Register Name: It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
User Name:
It is provided by ITSP for registration (required).
Password:
Server Host: It is provided by ITSP for registration (required).
Registered Register Failed
Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
Press the soft key when the phone is idle, select
-> ->
Press the soft key when the phone is idle, select
-> to configure the account.
For more information on account parameters, refer to
For more information, refer to the User Guide available online:
Copyright c 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.
key.
->
-> (X=1,2,3)
Registering
->
to configure the network.
->
.
www.yealink.com
(V72.4)
Applies to firmware version 72.1 or later.