Table of Contents
Advertisement
Terminals VMT6008
7.2 T
OUCH SCREEN DRIVER INSTALLATION
Note:
When installing the driver, you'll have to take in account that the touch screen monitor is
internally connected with the USB interface!
The installation has to be carried out as described below:
•
•
•
•
•
•
Pos : 37 /D atentec hni k/Sondergeräte-M odule/VMT 6000-Serie/VMT 6000-Software Tools @ 2\mod_1268751957235_6.doc @ 7393 @
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
The device does not have any integrated CD drive. The installation of the
operating system can therefore only be carried out by using the USB interface.
Access the service CD by using the Explorer and start the Installer file in the
TouchScreen folder.
Follow the on-screen instructions and acknowledge the licence terms and
conditions.
Once the installer has completed the installation, shut down the computer and
restart it subsequently.
After restarting, the touch screen monitor has to be calibrated. If the driver does
not automatically start, activate the setup menu via "Start => Settings =>
Control panel => Elo Touchscreen".
Via the "Calibration data" menu, calibrating the touch screen monitor can be
started, and the crosses appearing in a succession on the monitor have to be
pushed for calibration. If the cursor position perfectly matches the touch point of
your finger, you can exit this control menu by pushing "OK".
31
Advertisement
Table of Contents
