Table of Contents
Advertisement
2 O
PERATING INSTRUCTIONS
This device contains electrical voltages and extremely sensitive components. The
manufacturer, or a service partner authorised by the manufacturer, should be consulted if
you plan to make any modifications. For this type of work, the device must be switched off
at the mains and the power lead must be disconnected. Suitable measures for avoiding
electrostatic discharge towards parts of the components when touching the equipment
must be taken. If the device is opened by an unauthorised person, hazards for the user
might arise and any warranty claim will cease.
General instructions:
•
•
•
•
•
•
•
Warning:
Any leads (e.g. power leads, interface cables) may only be connected if the device is
switched off in order to avoid damaging the device.
2.1 O
PERATING LOCATION
The VMT control system is designed for use on support arm systems or on moving
transport equipment (like commissioning trolleys, forklifts or similar). You must take care
that the environmental conditions specified in the technical data specification are met.
Using the device in non-specified environments, for example, on board ships, or in areas
that might contain explosive gases or in extreme heights is prohibited.
Warning:
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. The same applies if the device has previously
been exposed to extreme temperature variations.
To avoid overheating in operation: The device must not be exposed to direct radiation by
sunlight or any other light or heat source.
2.2 D
AMAGE DUE TO IMPROPER USE
If the control system shows any obvious damage, e.g. caused by improper operating or
storage conditions or by improper use or handling, you must immediately put the device
out of operation and protect it from being accidentally switched on.
Pos : 13 /D atentec hni k/Betri ebs hi nweis e/Gewährleistung / R eparatur/Gewährleistung / R epar atur @ 0\mod_1158828054427_6.doc @ 223 @
10
All users must read this manual and have access to it at all times.
Installation, commissioning and operation may only be carried out by trained and
qualified staff.
The security instructions and the manual itself must be observed by all persons
who work with this device.
At the location of use the valid guidelines and regulations for accident prevention
must be observed.
The manual contains the most important instructions on how to use this device in
a safe way.
Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.
The device can be cleaned by using a soft cloth and a commercially available glass
cleaning agent (e.g. "Sidolin") with low alcohol content.
Terminals VMT6008
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Advertisement
Table of Contents
