Table of Contents
Advertisement
5.7 N
ETWORK CONNECTION
If the drivers required for functioning are installed on the device, the control system may
be integrated in an Ethernet network supporting the 10/100/1000 Mbit standard by using
the corresponding network cable via the Ethernet 10/100/1000 BaseT network connector.
Specifications of this network topology must be observed in this case. You can install the
drivers required for functioning from the enclosed service CD, should they not be installed
on the device.
PIN NUMBER
Pos : 32 /D atentec hni k/Schnitts tell en/Funknetz wer kkar te/Funknetz wer kkarte für VMT 6000 Serie @ 1\mod_1246364513539_6.doc @ 5856 @
Note:
The device has two separately integrated network controllers of the Realtek RTL 8111c
Family PCIe Gigabit Ethernet type.
Note:
PXE booting is only possible by using the LAN1 port.
Pos : 31 /D atentec hni k/Schnitts tell en/Funknetz wer kkar te/Funknetz wer kkarte für VMT 6000 Serie @ 2\mod_1260517076470_6.doc @ 6872 @
26
(RJ45)
SIGNAL NAME
1
2
3
4
5
6
7
8
TX +
TX -
RX +
NC
NC
RX -
NC
NC
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Terminals VMT6008
Advertisement
Table of Contents
