Table of Contents
Advertisement
Terminals VMT6008
10 C
OMPONENT REPLACEMENT
Warning:
Make sure that all cable connections are removed and that all supply voltages are
disconnected from the device!
10.1 O
PENING THE SERVICE SLOT
Remove the four screws holding the service slot on the rear of the device. The screws can
be removed by using a screw driver of Tx 10 size. By using the groove on the top of the
slot cover, you can tilt the rear cover to the front and finally remove it.
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
41
Advertisement
Table of Contents
