3.2 O
RDER OF STEPS DURING COMMISSIONING
R
EMOVING THE LID FROM THE SERVICE SLOT
Loosen the undetachable screws on the service slot cover by using a Torx Tx10 wrench
and subsequently remove the service slot cover from the device.
C
ONNECTING THE CABLES
Please connect all required cables. Use grommets in this case, in order to install the cables
correctly and to avoid any potential damage to the cables.
Note:
A cable installation kit, which includes grommets for several cable diameters, is available
as an option.
14
Terminals VMT6008
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen