Table of Contents
Advertisement
Terminals VMT6008
H
OW TO OPERATE THE SOFT KEYBOARD FROM VERSION
Note:
If a function is to be activated which requires pressing two keys at the same time (e.g. Alt
+ F4), these keys have to be pushed one after another at the soft keyboard, and the
special keys Shift, Alt and Ctrl must always be pushed first.
Due to differences in programming of a large variety of software programmes, we cannot
ensure that the soft keyboard works properly with all available software.
When deactivating the soft keyboard, the previously active state (alphanumeric / numeric
keys or function keys) will be stored and will be displayed when re-activating the
keyboard.
Pos : 22 /D atentec hni k/Bedienung/T ouch Scr een/T ouch Scr een für VMT 60xx/OPC 7000 @ 1\mod_1246361069977_6.doc @ 5853 @
4.3 T
OUCH SCREEN
The control system is equipped with a touch screen monitor. The touch screen monitor is
internally connected with the USB interface. The driver software required for using the
touch screen is integrated in the corresponding operating system, or can alternatively be
installed from the enclosed service CD.
Pos : 23 /D atentec hni k/Bedienung/Status-Anzeig en/SYS- LED/SYS- LED für VMT 60xx- Serie @ 2\mod_1260525540269_6.doc @ 6876 @
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Activate and deactivate the soft keyboard for letter/character input using
the touch screen
Switches numeric keys on and off (only if numeric keys are visible)
Switching between different representations (Alphanumeric keys
Numeric keys Function key bar)
Soft keyboard representation, zoom in
Soft keyboard representation, zoom out
3.11:
19
Advertisement
Table of Contents
