Table of Contents
Advertisement
Terminals VMT6008
3 C
OMMISSIONING
The power supply connection and interfaces of this device are installed underneath a
protective cover. This cover has to be removed in order to connect the power supply lead
and the interface cables.
All supply leads and all required data leads have to be connected before commissioning.
Warning:
The device must be switched off before connecting or disconnecting any cables in order
to prevent damage to the electronics!
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. Make sure to meet the permissible voltage
requirements for this device.
After switching off and before switching on you must wait for at least 5 seconds.
Note:
The screen of a data cable must always be connected with the connector housing (EMC).
Under the embedded operating system, interfaces must explicitly be enabled and required
drivers must be installed in order to be able to use them.
3.1 A
VAILABLE INTERFACES
Note:
If the case is connected with earth potential at the provided PE contact (e.g. by
connecting the PE contact with the device plug), the electrical insulation is no longer
given. This also applies if the device is installed by using a metal retainer clip.
If you want to have the device electrically insulated from the power supply, you have to
use a method of installation that ensures appropriate insulation.
Pos : 18 /D atentec hni k/Inbetri ebnahme/R eihenfolg e der Inbetriebnahme/R ei henfolge der Inbetriebnahme für VMT 60xx- Seri e @ 1\mod_1222073159179_6.doc @ 4100 @
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
13
Advertisement
Table of Contents
