Table of Contents
Advertisement
1. Wear a hard hat (safety helmet), safety glasses and /or face shield. It is also highly recommended that you
wear a dust mask, ear protectors and thickly padded gloves.
2、Be sure the bit is secured in place before operation.
3. Under normal operation, the machine is designed to produce vibration, the screws and bolts can come
loose, causing a breakdown and accidents. Check tightness of them carefully before running.
4、In cold weather or a long time tool not be used, please keep the tool running without load a few minutes
to warm up the grease inside, otherwise hammering function is difficult to get.
5、Be sure you stand stably and no one is below when you using tool is in high location.
6、Hold the tool firmly with two hands.
7、Don't touch any moving parts.
8、Don't leave the tool running itself, operate tool only when hand-held.
9、Don't point the tool to anybody for the bit could fly out in case.
10、When chipping into walls, floors or wherever "live" electrical wire may be encountered,
DON'T TOUCH ANY METAL PARTS OF THE TOOL! Hold the tool by the insulated grasping
surface to prevent electric shock if you chip into a "live" wire.
11、 Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may extremely
hot and could burn your skin.
12、Any damage and abnormal happen, please stop to use immediately and disconnect it, ask authorized
serve center to check and repair.
13. Parts replace: Only original XINPU's parts can be used to replace by authorized service center.
14. Right use accessories and parts: Don't use other parts and accessories which not mentioned in the
manual otherwise may cause injuries!
15. Special attention to voltage: Before connect the power tool, please make sure the rated voltage on the
tool can match the power supply, otherwise the power tool may be damaged and cause injuries.
16. Don't wipe plastic part with solvent: Solvent such as gasoline, thinner, alcohol etc. these kind of
chemical material, are not allowed to use, water or soap are recommended!
17. In case of damages the replacement of the plug or the supply cord shall always be carried out by the
manufacturer of the tool or his service organization
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the power tool's construction and design:
a) Injuries and damage to property to due to broken accessories that are suddenly dashed.
b) Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
c) Lung damage if don't use dusk mask.
d) Hearing damage if don't use ear protection.
Warning! This power tool produces an electromagnetic field during operation. This field
may under some circumstances interfere with active or passive medical implants. To reduce
the risk of serious or fatal injury, we recommend persons with medical implants to consult
their physician and the medical implant manufacturer before operating this power tool.
Assembly
3.
7
Advertisement
Table of Contents
