Advertisement
3. Assembly
Name of the parts
Mounting tool bits
Warning: before do it, make sure unplug the machine!
(1) Pivot the tool retainer to the side.
(it's difficult to move the retainer with
your thumbs, tap it with a hammer.)
insert the bit into the tool barrel as
far as it is, then return the retainer
to its original position.
(2) to pull out the bit follow the
install procedure in reverse.
4. Operation
Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which specified
on the name plate of the hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power
receptacle while the power switch is in ON position, the demolition hammer will start operation
immediately, which can cause serious accident!
Advertisement
