Special Tools - Yamaha 2004 YP400 Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
NOTE:
• For U.S.A. and Canada, use part number starting with "YM-", "YU-", or "ACC-".
• For others, use part number starting with "90890-".
Tool No.
90890-01235
YU-01235
90890-01268
YU-01268
90890-01304
YU-01304
Radiator cap tester
90890-01325
YU-24460-01
Radiator cap tester
adapter
90890-01352
YU-33984
T-handle
90890-01326
Damper rod holder
90890-01460
90890-01348
YM-01348
Tool name/Function
Rotor holding tool
This tool is used to hold the primary fixed
sheave and clutch shoe assembly.
Ring nut wrench
This tool is used to loosen or tighten the
steering ring nuts.
Piston pin puller set
This tool is used to remove the piston
pins.
Radiator cap tester
Radiator cap tester adapter
These tools are used to check the cooling
system.
T-handle
Damper rod holder
These tools are used to hold the damper
rod when removing or installing the
damper rod.
Locknut wrench
This tool is used to remove or install the
clutch shoe assembly nut.
SPECIAL TOOLS
1 - 13
GEN
INFO
Illustration