Special Tools - Yamaha XC50V Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool NO.
90890-01085
YU-01083-2
90890-01084
YU-01083-3
90890-01235
YU-01235
90890-01268
YU-01268
90890-01304
YU-01304
90890-01312
YM-01312-A
90890-01337
YM-33285
YM-33285-6
90890-01348
YM-01348
90890-01325
YU-24460-01
90890-01352
YU-33984
Tool name / Function
Slide hammer bolt (8mm) 1
Weight 2
These tools are needed to remove the cam-
shaft.
Rotor holding tool
This tool is used to remove the flywheel
magneto.
Ring nut wrench
This tool is used to loosen and tighten the
exhaust and steering ring nut.
Piston pin puller set
This tool is used to remove the piston pin.
Fuel level gauge
This gauge is used to measure the fuel level
in the float chamber.
Clutch spring holder
These tool are used for removing the nut with
holding the compression spring.
Lock nut wrench
This tool is used when removing or install-
ing the secondary sheave nut.
Radiator cap tester1
Radiator cap tester adapter2
This tester and its adapter are needed for
checking the cooling system.
SPECIAL TOOLS
1-6
GEN
INFO
Illustration
1
2
41
46
1
2