Yamaha 2004 YP400 Service Manual page 197

1
2
1
2
b
a
4 - 57
HANDLEBAR
2. Install:
• handlebar 1
• upper handlebar holders 2
CAUTION:
_
First, tighten the bolts on the front side of
the handlebar holders, and then on the rear
side.
NOTE:
_
• The upper handlebar holders should be
installed with the arrow marks a facing for-
ward È.
• Align the match marks b on the handlebar
with the upper surface of the lower handlebar
holder.
3. Install:
• handlebar grip
M MMM M MMM M M MMM M
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
@
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
L LLL L LLL L L LLL L
4. Install:
• rear brake master cylinder 1
• rear brake master cylinder holder 2
NOTE:
• Make sure to install the brake master cylin-
der holder that has the "L" mark.
• Install the rear brake master cylinder holder
with the "UP" mark facing up.
• Align the end of the rear brake master cylin-
der holder with the punch mark a in the han-
dlebar.
• First, tighten the upper bolt, then the lower
bolt.
CHAS
23 Nm (2.3 m · kg, 17 ft · lb)
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
10 Nm (1.0 m · kg, 7.2 ft · lb)
MMM
LLL