Section 12: Wing And Canopy Hatch Installation - Hangar 9 RV-8 Assembly Manual

Hangar 9 RV-8 Assembly Manual
important: Make sure the flap servo is in the "UP"
position before measuring and marking the flap linkage.
Hint: A small piece of blue tape on the flap servo leads
will help in identifying the leads when the wing is being
installed on the fuselage.

Step 24
Repeat Steps 1 through 23 to install the aileron and flap
servos in the opposite wing panel.
Section 12:
Wing and Canopy Hatch installation
Required Parts
Wing panel (right and left) Fuselage assembly
Aluminum wing tube Canopy hatch assembly
3mm washer (2) 3mm washer (4)
3mm x 15mm socket head screw (2)
3mm x 20mm socket head screw (2)
Tools and Adhesives
Hex wrench or ball driver: 2.5mm
Hobby knife with #11 blade

Step 1
Use a hobby knife with a #11 blade to remove the covering
on both sides of the fuselage to access the wing tube, wing
mounting tab, wing anti-rotation pin and servo extension
openings. Remove the covering on the bottom of the fuselage
as well to access the holes for the wing mounting screws.
37