Jump-Starting - BMW C 650 GT Rider's Manual

Remove bulb from socket.
Replacing defective bulb.
Bulb for license-plate
light
W5W / 12 V / 5 W
To protect the glass on the
new bulb against contamina-
tion, always use a clean, dry
cloth to hold it; do not touch
with bare fingers.
Insert bulb in socket.
Insert socket 1 in light housing.

Jump-starting

The wires leading to the
power socket do not have a
load-capacity rating adequate for
jump-starting the Maxi-Scooter.
Excessively high current can lead
to a cable fire or damage to the
motorcycle electronics.
Do not use the onboard socket
to jump-start the engine of the
Maxi-Scooter.
A short-circuit can result
if the crocodile clips of
the jump leads are accidentally
brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the motorcycle
electronics.
The battery of the donor vehicle
must have a voltage of 12 V.
9
105
z