Synchronization - BMW C 650 GT Rider's Manual

Acknowledgment tone sounds
5
once.
Switch off the ignition within
58
ten seconds.
Press button 2 three times.
Acknowledgment tone sounds
once.
Switch on the ignition within
ten seconds.
Acknowledgment tone sounds
twice.
You can log on a maximum of re-
mote controls for the DWA. The
logon for each remote control is
carried out in three steps.
Press and hold button 1 and
button 2.
LED flashes for ten seconds.
As soon as the LED goes out,
release button 1 and button 2.
LED lights up.
z Press button 1 or button 2.
Alarm tone sounds once.
LED goes out.
Remote control is logged on.
Repeat the three previous work
steps for each additional re-
mote control.
Logon ended
The logon is ended if
four remote controls have been
logged on
the ignition is switched off
no button was pressed for 30
seconds after the ignition was
switched off
no button was pressed for 30
seconds after a remote control
was logged on
After the logon is completed, the
LED flashes and the acknowledg-
ment tone sounds three times.

Synchronization

with anti-theft alarm OE
When is it necessary to
synchronize the remote
control?
The remote control must be syn-
chronized when the buttons of
the remote control has been op-
erated more than 256 times out-
side the range of the receiver.
In this case, the receiver on the
motorcycle no longer reacts to
the signals of the remote control.
Synchronize remote
control
Press and hold button 1 and
button 2.