BMW C 650 GT Rider's Manual page 102

9
100
Loosen fastening screws 2 on
left and right.
Push mounts 3 on left and
right far enough apart that front
z
suspension fits between them.
Use locating pins 4 on left and
right to set front wheel stand to
desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 3 on left and
right so that front suspension
rests securely on them.
Tighten fastening screws 2 on
left and right.
If the Maxi-Scooter is raised
too far at the front, the cen-
ter stand lifts off the ground and
the Maxi-Scooter can tilt to the
side.
When raising the motorcycle,
make sure that the center stand
remains on the ground. Adjust
the height of the front wheel
stand if necessary.
Press down front wheel stand
evenly to raise Maxi-Scooter.
Ensure Maxi-Scooter is stand-
ing securely.