BMW C 650 GT Rider's Manual page 98

9
96
Clamping screws (quick-
release axle) in tele-
scopic forks
z
Tightening sequence: Tighten
the screws 6 times, alternating
between one and the other
each time
6 lb/ft (8 Nm)
Remove front wheel stand.
Slide the brake calipers onto
the rotors.
Install screws 2 on left and
right with appropriate torque.
Brake caliper on fork leg
21 lb/ft (28 Nm)
The cable of the wheel
speed sensor could chafe
through if it comes into contact
with the brake disk.
Make sure that sensor cable is
routed correctly.
Insert ABS sensor in its socket
and install screw 1.
Remove adhesive tape from
wheel rim.
Press handbrake lever firmly
a number of times until resis-
tance point is noticeable.
Mount front wheel cover and
install screws 1 and 2 on right
and left.
Removing rear wheel
Make sure ground is level and
firm and place Maxi-Scooter on
its center stand.