Jump-Starting - BMW C 650 GT Rider's Manual

8
126
Replace faulty fuse from the
fuse carrier with a fuse with the
required current level.
z
NOTICE
The fuse assignments and fuse
amperage ratings specified for
your motorcycle are listed in the
section entitled "Technical data".
The figures in the graphic corres-
pond to the fuse numbers.
Installing side panel (

Jump-starting

ATTENTION
Excessive current flowing
when the Maxi-Scooter is
jump-started
Wiring smoulders/ignites or dam-
age to the on-board electronics
If the Maxi-Scooter has to be
jump-started connect the leads
to the battery terminals; never
attempt to jump-start the en-
gine by connecting leads to the
on-board socket.
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
122).
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
https://www.motorcycle-manual.com/
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board elec-
tronics
Make sure that the battery of
the donor vehicle has a voltage
rating of 12 V.
Make sure the ground is level
and firm and place the Maxi-
Scooter on its stand.
Remove the side panel
( 121).
Begin by connecting one end
of the red jump lead to the
vehicle's battery positive ter-
minal and the other end to the
positive terminal of the donor
vehicle's battery.
Connect one end of the black
jump lead to the vehicle's bat-
tery negative terminal and the
other end to a suitable ground-
ing point on or the negative