Panel Maintenance; Copy Maintenance; Scanner Maintenance - Oki MC361 Service & Troubleshooting Manual

Test Print Menu
Switches between displaying and not displaying the "ID Check" and "Engine
Information" in the "Report" - "Print Report" category (default: DISABLE). If this item is
set to "DISABLE," the "ID Check" and "Engine Information" will remain undisplayed at
all times. The printer will reboot after changing the settings and exiting the menu.
Change Password
Set a new password for accessing the maintenance menu. 6 to 12 characters (numerals
and lower-case alphabetic characters) may be entered.
It is highly recommended that you
changed password is lost, the main control board and hard disk drive would need
replacement. This is not a covered expense under any machine warranty and you will
incur the cost of the replacement components.
Check RTC
Displays a snapshot of the current time. (The time does not change during display.)
Save Syslog
Saves the network communication log (syslog) to nonvolatile memory.
Print Syslog
Prints the network communication log (syslog).

2.4 Panel Maintenance

Buzzer Test
Select the volume of the forced buzzer. For the buzzer pattern, use the error sound (three
buzzes)

2.5 Copy Maintenance

Color Copy
Switches between enabling and disabling pressing the color start key during copying. If
this is set to "disabled," presses on the color start key in copy mode will be rejected by
the panel.
Print Check Pattern
Starts printing from the panel using a copy evaluation test chart inside the FW.

2.6 Scanner Maintenance

Scanner Calibration
Starts execution of scanner calibration. Instead of being conducted automatically after
operating for a certain period of time, calibration is executed by the user as needed.
During calibration, the fact that calibration is underway is displayed.
Note: Also included under AdminSetting.
change this password. In the event that the
DO NOT
13