Test Print - Oki MC361 Service & Troubleshooting Manual

Motor & Clutch Restrictions
Unit name displayed
ID MOTOR
BELT MOTOR
FUSER_MOTOR
REGIST MOTOR
T1 HOPPING MOTOR
FRONT MOTOR
REGIST SHUTTER
DUPLEX MOTOR
DUPLEX CLUTCH
T2 HOPPING MOTOR
T2 FEED CLUTCH
ID UP/DOWN
LV FAN TEST
ID FAN TEST
FRONT FAN TEST
Note: Display while ID UP/DOWN is in progress
Display after holding down REGIST SHUTTER [6] button

2.8.3 Test Print

The test printing is used for printing test patterns stored in the PU. The controller stores
the other patterns.
The test printing cannot be used to check print quality.
1. Enter the self-diagnostic mode and, until TEST PRINT appears on the upper
display, press
[2]
preceding option). Then press the
2. A setting option applied only to test printing appears on the lower display. Press
or until a target option appears
[2] [8]
displays the preceding option). Then press the
options do not need to be set (left set to their defaults)].
Driving restriction
All of the (black, yellow,
magenta and cyan) image drums
must be removed.
All of the (black, yellow,
magenta and cyan) image drums
must be removed.
–
–
–
–
–
–
–
–
–
The top and front cover must be
closed.
–
–
–
***: Identifies the number of executions
***: Identifies the number of executions
or [8] ([2] displays the next test option and
button.
[6]
([2]
Remarks
displays the
[8]
displays the next option and
button. [Go to step 5 when the
[6]
–
–
–
–
–
–
–
–
–
Option
Option
–
–
–
–
[8]
27