Switch Scan Test - Oki MC361 Service & Troubleshooting Manual

The following is the normal self-diagnostic mode menu:
Option

1 Switch scan test

(See section 2.8.1)
2 Motor and clutch test
(See section 2.8.2)
3 Test printing
(See section 2.8.3)
4 Color registration
adjustment test
(See section 2.8.4)
5 Density adjustment test
(See section 2.8.5)
6 Consumable counter
display
(See section 2.8.6)
7 Consumable life counter
display
(See section 2.8.7)
8 Factory/Shipping mode
setting
(See section 2.8.8)
9 Fuse status display
(See section 2.8.9)
10 Engine parameter setting
(See section 2.8.10)
11 NVRAM parameter setting
(See section 2.8.11)
2.8.1 Switch Scan Test
The switch scan test is used for input sensor and switch checking.
1. Enter the self-diagnostic mode (level 1) and, until SWITCH SCAN appears on
the upper display, press
displays the preceding test option). Then press the
2. Press or
[2] [8]
appears on the lower display
preceding option).
Self Diagnostic Menu
Item
SWITCH SCAN
MOTOR&CLTCH TEST
TEST PRINT
REG ADJUST TEST
DENS ADJ TEST
CONSUMABLE STATUS
PRINTER STATUS
FACTORY MODE SET
SENSOR SETTING
NVRAM PARAMETER
or [8] ([2]
[2]
until the option for unit(s) to test, which is shown in table below,
([2] displays the next option and
Adjustment
Performs input sensor and switch
checking.
Tests motor and clutch
operation.
Prints a test pattern stored in the PU.
Judges the color registration
adjustment mechanism as pass or fail.
Judges the density adjustment
mechanism as pass or fail.
Displays consumable usage.
Displays consumable life.
Switches between the Factory and
Shipping modes
Displays the status of the fuses.
Sets whether to enable or disable
error detection performed by each
sensor.
Must not be used.
displays the next test option and
button.
[6]
[8]
displays the
[8]
23