Self-Diagnostic Function Setup - Oki MC361 Service & Troubleshooting Manual

Table of Contents

Advertisement

4. Hold down the
to set. The setting is stored in the EEPROM. The state for step 2 is restored.
5. Repeat steps 2 through 4 when necessary.
6. Press
to end the option (the state for step 1 is restored).
[4]
Display
FACTORY MODE
FUSE INTACT
Indicates whether fuse is
Note!
INTACT or BLOWN. Six
asterisks
(******) identifies INTACT or
BLOWN.

2.8.9 Self-diagnostic function setup

The self-diagnostic function setup is used for enabling or disabling the error detection by
sensors. The detection can be enabled or disabled temporarily for troubleshooting.
Allowing for setting engine operation options for which expert knowledge is required to
be handled, these self-diagnostic setup should be used carefully.
Be sure to restore the default settings of used options of the self-diagnostic function setup.
1. Enter the self-diagnostic mode and, until the following message appears, press
or [8].
2. Press
or
[2]
[8]
to set (refer to the table shown below) appears.
3. A setting can be selected on the lower display by pressing the
displays the next setting and
4. Hold down the
to set. The setting is stored in the EEPROM. The state for step 2 is restored.
5. Repeat steps 2 through 4 when necessary.
6. Press
to end setting the option (except where not in step 4) (the state for step 1
[4]
is restored).
button (for three seconds) with the display showing the setting
[6]
Settings
FACTORY MODE
SHIPPING MODE
BELT UNIT ******
FUSE UNIT ******
ID UNIT ******
and the following message appears. Press
displays the preceding setting.
[8]
button (for three seconds) with the display showing the setting
[6]
Function
Sets up the Factory work mode.
This is a production mode.
The unit should always be
Note!
set for Shipping mode or erratic
operation may result.
Sets up the Shipping mode for
normal operation.
Checks the FUSE status of the
transfer belt unit.
Checks the FUSE status of the
fuser.
Checks the FUSE status of the ID
unit.
or
until an option
[2]
[8]
button.
[6]
[2]
[2]
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mc561Cx2731mfp

Table of Contents