Oki MC361 Service & Troubleshooting Manual page 45

Initial Actions to Perform
■ Perform Initial Actions from
■ Verify the media used
■ Verify the media settings
■ Print the ID Check Pattern
page (Setting - Reports – System – Demo Page)
■ Perform isolation Test Prints
■ Run the Density Adjustment Test
Areas of the Printer that Apply
■ Imaging Unit
■ Fuser
■ Transfer Unit
Repeating Defects Spacing
Component
Imaging Drum
Developer Roller
Charge Roller
Supply Roller
Fuser Belt
Heat Roller
Transfer Roller
Mis-Registration, Color Layers Not Correctly Registered
The image appears blurred and the primary colors are not aligning correctly onto the final image.
Initial Actions to Perform
■ Perform Initial Actions from
■ Verify the media used
■ Verify the media settings
■ Print the ID Check Pattern
page (Setting - Reports – System – Demo Page)
■ Perform isolation Test Prints (Section 2.8.3).
■ Run the Color Registration Adjustment Test
Areas of the Printer that Apply
■ Imaging Unit
■ LED Heads
■ Color Registration Sensors
■ Transfer Unit
■ HVPS
■ CU Board
■ PU Board
Maintenance Procedures in Chapter
is supported by this printer.
are correct at the Control Panel.
(Setting - Reports – Print – ID Check Pattern)
form Section 2.8.3.
in Section 2.8.5.
Defect Spacing
94.3 mm
30.2 mm
29.9 mm
43.1 mm
94.2 mm
85.4 mm
37.7 mm
Maintenance Procedures in Chapter
is supported by this printer.
are correct at the Control Panel.
(Setting - Reports – Print – ID Check Pattern)
1.
to see if it is an application problem.
Defect Location
Imaging Unit
Imaging Unit
Imaging Unit
Imaging Unit
Fuser
Fuser
Transfer Unit
1.
to see if it is an application problem.
(Section 2.8.4)
and Demo
and Demo
45