Real Time Clock - Toshiba TECRA A10 Satellite Pro S300 Series User Manual

Real Time Clock

Problem
The following message
is Displayed on the
screen:
RTC battery is
low or CMOS
checksum is
inconsistent.
Press [F1] key to
set Date/Time.
Password
Problem
Cannot enter password Please refer to the
Keyboard
Keyboard problems can be caused by the setup and configuration of the
computer - please refer to Chapter 5,
Problem
Some letter keys
produce numbers
Output to screen is
garbled
Downloaded from LpManual.com Manuals
User's Manual
Procedure
The charge in the Real Time Clock (RTC) battery
has run out - you will need to set the date and
time in the BIOS setup application by using the
following steps:
1. Press the F1 key - the BIOS setup application
will load.
2. Set the date in the System Date field.
3. Set the time in the System Time field.
4. Press the END key - a confirmation message
will be displayed.
5. Press the Y key - the BIOS setup application
will end and the computer will restart.
Procedure
section in Chapter 6, Power and Power-Up
Modes for further information.
The Keyboard
Procedure
Check that the numeric keypad overlay is not
activated - press the FN + F11 hot key and try
typing again.
Please refer to your software's documentation to
ensure that its is not remapping the keyboard in
any way (remapping involves changing or
reassigning the function of each key).
If you are still unable to use the keyboard, you
should contact your reseller, dealer or service
provider.
Troubleshooting
TOSHIBA Password Utility
for further information.
8-7