Installing A Memory Module - Toshiba TECRA A10 Satellite Pro S300 Series User Manual

Point to note about memory module error
If you install a memory module that is not compatible with the computer, the
Power indicator will flashes (on for 0.5 seconds, off for 0.5 seconds) in the
following ways;
■
■
■
In all instances you should shut down the computer and remove the
incompatible module(s).
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.

Installing a memory module

To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
2. Remove the AC adaptor and all cables and peripherals connected to
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
5. Loosen the one screw securing the memory module cover in place -
Use a point size 0 Phillips screwdriver.
Downloaded from LpManual.com Manuals
User's Manual
If there is an error in only Slot A or no memory module is inserted in Slot
A: repeatedly flashes orange twice, then green.
If there is an error in Slot B: repeatedly flashes orange, then green
twice.
If there are errors in both Slot A and Slot B: repeatedly flashes orange
twice, then green twice.
the Turning off the power
required).
the computer.
Replacing the battery pack
Modes, if required).
please note that this screw is attached to the cover in order to prevent it
from being lost.
Hardware, Utilities and Options
section in Chapter 1, Getting Started if
section in Chapter 6, Power and Power-Up
3-25