Volume Control Dial - Toshiba TECRA A10 Satellite Pro S300 Series User Manual

Volume control dial

Problem
No sound is heard
Annoying sound is
heard
External monitor
Please also refer to Chapter 3,
documentation supplied with your monitor for further information.
Problem
Monitor does not turn
on
No display
Downloaded from LpManual.com Manuals
User's Manual
Procedure
Adjust the volume control dial.
To increase the volume move the volume control
dial to the right, and to decrease it move the
volume control dial to the left.
Turn the volume control dial while verifying the
volume in order to adjust.
Volume cannot be adjusted during Windows start
up or shut down.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Hardware, Utilities and
Procedure
After confirming that the monitor's power switch
is on, you should check the connections to make
sure that the power cord/adaptor is firmly
connected to the monitor and to a working power
outlet.
Try adjusting the contrast and brightness controls
on the external monitor.
Press the FN + F5 hot key in order to change the
display priority and ensure that it is not set for the
internal display only.
Check to see if the external monitor is connected.
When the external monitor is set as the primary
display device in extended desktop mode, it will
not display when the computer wakes up from
Sleep Mode if the external monitor has been
disconnected while in Sleep Mode.
To keep this from happening, do not disconnect
the external monitor while the computer is in
Sleep or Hibernation Mode.
Remember to turn off the computer before
disconnecting the external monitor.
Troubleshooting
Options, and to the
8-25