Remote Voltage/Amperage Control - Miller Big Blue 800 DUO PRO Owner's Manual

6-9. Remote Voltage/Amperage Control

CC Welding
In Example:
Min = 20 A DC
Max = 205 A DC
Connect Remote
Control To Remote
Receptacle RC14
CV Welding
Electrode Hot: Voltmeter tog-
gles between preset and ac-
tual output when not welding,
actual voltage while welding.
Remote On/Off Required:
Voltage shown is preset.
Connect Remote
Control To Remote
Receptacle RC14
OM-262 752 Page 42
.
Complete Parts List available at www.MillerWelds.com
2 3
1
Voltmeter Shows Open-Circuit
Voltage When Not Welding, Arc
Set TIG or STICK Process
28
Set WIRE Process
1 Remote 14 Receptacle
Connect optional remote control to receptacle
(see Section 5-15).
.
When a remote control is connected to the
Remote receptacle, the Auto Sense Re-
mote feature automatically switches volt-
age/amperage control to the remote con-
trol. When a device is connected to the Re-
mote receptacle, remote voltage/amper-
age control is always available regardless
of the position of the Process/Contactor
switch.
2 Voltmeter
3 Ammeter
Voltage While Welding
Turn Remote Control On. Ad-
just Optional Remote
Control to 100%
0
Ammeter Shows Zero
Adjust Optional Remote
Control to desired
weld output
85
205
Ammeter Shows Preset
Output When Not Welding,
Actual Amperage While
Welding
Set V/A Control
To Desired Maximum
Weld Output Using Weld
Meters
Max (205 A DC)
Min (20 A DC)
Adjust Optional Remote
Control to desired
weld output
0774 / Ref.246 345-B / Ref. 907 561−06