Connecting The Battery - Miller Big Blue 800 DUO PRO Owner's Manual

5-4. Connecting The Battery

Tools Needed:
1/2 in.
!
Connect negative (−) cable last.
NOTICE − Wait two minutes after engine
shutdown before disconnecting battery or
engine controller may be damaged.
Battery is most easily accessed through
the rear panel. Remove battery access
panel from rear panel. Connect battery,
negative cable last. Reinstall battery ac-
cess panel.
Notes
OM-262 752 Page 24
.
Complete Parts List available at www.MillerWelds.com
−
+
S
Do not allow the battery cables to
touch opposing terminals. When connect-
ing the battery cables attach the positive
(+) cable to the positive (+) battery termin-
al first, followed by negative (−) cable to
negative (−) battery terminal.
S
Never start the engine when the
cables are loose or poorly connected to
the battery terminals.
Conn_batt1 2008−02 802 168-E / Ref. 202 705 / 802 313 / S-0756-C
S
Never disconnect the battery while
the engine is running.
S
Never use a quick battery charger to
start the engine.
S
Do not charge battery with Engine
Control switch On.
S
Always disconnect the negative (−)
battery cable before charging battery.