Section 12 − Engine Information Display - Miller Big Blue 800 DUO PRO Owner's Manual

SECTION 12 − ENGINE INFORMATION DISPLAY
.
The views in this section are intended to be representative of all engine-driven welding generators. Your unit may differ from those shown.
12-1. Display Layout And Controls
4
3
12-2. Function Buttons
Function Button
6-Up Display
1-Up Display
OM-262 752 Page 60
Previous Next
None None
Previous Next
1
5
2
Menu/Cancel View
Menu Go to 1-Up
Menu Go to 6-Up
1 Engine Information Display
2 Engine Control Switch
3 Function Buttons
4 Yellow LED
5 Red LED
The Engine Information Display
turns on whenever the Engine Con-
trol switch is in either Run or Run/
Idle with the engine not running.
.
When starting the engine,
pause Engine Control switch in
Run or Run/Idle position for
several seconds. The engine
controller initiation sequence
must occur. If glow plugs are on
(automatically determined by
ambient temperature), also
wait until the initial Wait to Start
message on the display is
cleared (see Section 12-4).
Function buttons are used to navi-
gate through menus, increment/
decrement, and select (see Section
12-2).
The yellow LED lights as part of se-
quences used to alert the operator
to errors or conditions that will affect
operation, such as low fuel.
The red LED lights as part of a shut-
down sequence, such as when fuel
is too low or oil pressure is too low
to continue operation without dam-
aging the engine.
258 833-C
Enter/Diagnostic
Engine Diagnostics
Engine Diagnostics