Table of Contents
Advertisement
mode in the Administration/Communications/LocalTalk, Administra-
tion/Communications/Serial, Administration/Communications/Parallel,
and Administration/Communications/Network x / Optional Interface
menus (if installed).
Blank Pages
n
If a blank start-up page ejects or blank pages come out during a
printing job, check for an empty, defective, or missing cartridge.
n
Make sure you have broken the tab on the side of the toner car-
tridge and removed the sealing tape.
n
Check to ensure that you are not using perforated or 3-hole-
punched paper). This type paper is not recommended for your
printer.
End-of-Document (EOD) Command Problems
The information in this section is intended to assist you in recognizing
and fixing EOD problems.
n
If you add an EOD command to your file and the EOD command
prints on your job, you may need to set the end job mode on the
printer's control panel. See "Setting the End Job Mode for the
Serial and Parallel Protocols" in chapter 5, "Additional Technical
Information," of the Reference for more information.
n
If your QMS Crown printer is not interpreting the selected EOD
command correctly for your print job, then do the following:
-
Check the syntax and spelling of the EOD command in your
file or network job separator, depending on your environment.
-
Check that the end job mode on the printer's control panel
and the EOD command in your file or network job separator,
depending on your environment, match.
-
Check with your system administrator or applications devel-
opment department to ensure that you are using the standard
EOD command for your organization.
Troubleshooting
Output
Problems
6-29
Advertisement
Table of Contents
