Table of Contents
Advertisement
Finding the Strongest Signal
When installing your Signal Booster's Outside Antenna, aiming it towards
the best signal source from you service provider is important . The
best way of getting the strongest signal is to have one person on the
roof to rotate the Outside Antenna, which is connected to the Signal
Booster . Turnt the Outside Antenna about 45 degrees at a time, while the
second person is watching the signal strength on the phone inside the
building . This allows you to read the signal strength from the cell tower .
It is preferable to have the phone in the test mode so the actual signal
strength can be read, as bars are not the most accurate . Go to
www.WilsonElectronics.com for help in finding the test mode for your
phone . Always make sure the person inside the building gives the signal
time to arrive and register on the phone (between 10-30 seconds for
phone to reset to the signal reading) .
Cell Signal
Outside
Wide Band
Cell Tower
Antenna
Signal readings usually appear as a negative number (for example, -86) .
The closer you get to zero the stronger the signal . (See graph below) .
Signal Strength Graph
EXCELLENT
GOOD
POOR
NO
SIGNAL
-50dB
-60dB
-70dB
-80dB
-90dB
-100dB
-110dB
7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Mon.- Fri. Hours: 7 am to 6 pm MST.
Advertisement
Table of Contents
