Troubleshooting; Residual Heat Indicators “H”; Auto Stand By - Belling Hob Users Manual & Installation Handbook

UsInG tHe HoB - InDUctIon
This helps to reduce the risk of fire
through misuse of the hob.
If there is an overheat situation, the hob
will display the appropriate code detailed
in the "hob status codes table" (next
page).
approx Glass
temperature c
o
190
220
note:-
The safety temperature control of the
pans is only possible with quality flat bot-
tomed pans suitable for induction cook-
ing; Poor quality pans can create air gaps
between the glass and the pan, which
affects the accuracy of the temperature
control.
Residual Heat Indicators "H"
If the glass surface is above 65
the cook zone is switched off, a "H" will
be displayed in the cook zone display until
the glass surface drops below approxi-
mately 55 c.
o
This feature not only warns you against
hot surfaces but also indicates that there
is residual heat which can be used as a
temporary warm zone.
note:
The cook zone itself does not heat up, but
the ceramic glass does get hot because
of the hot pan conducting heat back onto
the hob glass.

auto stand by

the Hob will automatically switch off
if left (with pan) on for an extended
period of time, see maximum run-
ning times below.
Hob action
Automatic Power
reduction
Power Automati-
cally Shuts down
c when
o
power level
1
2
3
4
5
6
7
8
9
"P" (Power Boost)

tRoUBlesHootInG

The hob produces a smell the first
few times it is used.
Heat a pan full of water on each zone for
half an hour.
pans make a noise during cooking
This is caused by vibration due to the pas-
sage of energy from the hob to the pan.
On a high setting this is quite normal for
certain types of saucepan. It will not dam-
age the hob.
the hob makes a slight clicking
sound
This is caused by the distribution of power
between two heating zones on the same
side of the hob.
the fan keeps working for a few
minutes after the hob has been
turned off
To cool down the electronics.
the hob won't work, the indicators
don't come on
The electricity supply is not reaching the
appliance (faulty supply or connection);
check the fuses and the cut-out switch.
Maximum
operation time
hours
10
5
5
4
3
2
2
2
1
Max 10 mins