Page 1
Users Guide & Installation Handbook Belling 60 - 70 - 90cm Hob Rotary UK Part No 082756702 Date 11.07.2012...
Page 2
Customer care Apply a thin coat of ceramic hob cleaner representatives become available. to the hob to help maintain and protect it. Alternatively, general information, spares See the customer care section for details and service information is available from of how to obtain all the available cleaning products.
Page 3
WARNING!-Unattended system. cooking on a hob with fat or oil can be dangerous and may result in a fi re. NEVER Try to extinguish a fi re with water but...
Page 4
Do not spray aerosols in the vicinity of this appliance while it is in operation. If you’re called away from the hob - by the phone or someone at the door, either Do not store or use fl ammable liquids or take pans off the heat, or switch off your items in the vicinity of this appliance.
Avoiding damage to the appliance. For additional details regarding the recy- cling of this product please contact your The ceramic glass of the hob can be local government offi ce, your household damaged by objects falling onto it. Be waste disposal service or the retailer especially careful with heavy jars of food where you purchased the product.
Page 6
The glass surface of the hob gets extremely hot during and after use, under no circumstances allow any person and especially children to touch, sit or stand on the hob glass surface. • Allow the hob to fully cool, which can take approx 30 mins before the hob is safe to touch e.g.
Page 7
fi rst time. Apply a thin • For cleaning, the appliance must be coat of ceramic hob cleaner to the switched off and cooled down. hob to help maintain and protect it. WARNING! Risk of burns from residual •...
Partition CHOOSING YOUR INSTALLATION We recommend that you install this ap- pliance in a work top which is a minimum 38mm deep. The hob can be fi tted into a work top less than 38mm deep, but the 25mm gap...
Page 9
No shelf or overhang of combustible There must be a minimum clearance of material should be closer than 650mm 50mm between the rear edge of the hob above the hob. and the rear wall. This clearance must be maintained up to 650mm above the There must be a minimum clearance of worktop.
Tighten with humidity. the screws so that the hob is pulled down Apply a suitable sealant to the cut edge to fi rmly against the worktop, thus ensuring protect it from moisture ingress.
Page 11
INSTALLATION POSITIONS clips detailed in pack 1. If your appliance is not supplied with spire clips, the installation brackets screw directly into the base of the hob in the ported holes provided. 30mm INSTALLATION POSITIONS Depending on your appliance it will be 70 &...
Page 12
Door release tab Important: Ensure that you route all Cable clamp ratchet mains electrical cables well away from any Cable clamp screw adjacent heat source, such as the base of the hob an oven or grill.
TECHNICAL DATA SUPPLY: 220 -240V ~ 50Hz 4.85kW - 6.20kW Refer to the data badge on the under side of your hob for specifi c power rating of your model...
In addition to the list of our most popular products below, we also have an exciting Product De- Where used Purpose scription Enables easier cleaning of your ceramic hob. All Ceramic glass Ceramic Hob Prevents build up of mineral deposits. Best hobs including Cleaner used with Ceramic Hob Scraper Kit.
Page 15
Please keep this handbook for future reference, or for anyone else who may use the appliance.
Page 16
CUSTOMER CARE To contact Belling about your appliance, please call Warranty Registration 0844 481 0182 to register your appliance Customer Care Helpline 0844 815 3746 in case of diffi culty within the UK Alternatively general, spares and service information is available from our website at www.belling.co.uk...
Need help?
Do you have a question about the Hob and is the answer not in the manual?
Questions and answers