Table of Contents
Advertisement
Connect to the electricity supply
For hobs that are supplied/manufactured
with a 13Amp supply cord and plug only.
Warning: Ensure that the power rating of
the appliance is compatible with a 13Amp
supply before connecting to the electricity
supply, i.e. 2.8kW.
Warning: This appliance must be
earthed.
The flexible mains lead is supplied con-
nected to a BS 1363 fused plug, the plug
is fitted with the correct fuse.
Replace only with a fuse of the same rat-
ing and type.
The wires in the mains lead are coloured
in accordance with the following code:
Green and yellow = Earth,
Blue = Neutral,
Brown = Live.
As the colours of the wires in the mains
lead for the appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1. The wire which is coloured green and
yellow must be connected to the terminal
marked E (Earth) or coloured Green.
2. The wire which is coloured blue must
be connected to the terminal marked N
(Neutral), or coloured Black.
3. The wire which is coloured brown must
be connected to the terminal marked L
INSTALLATION
(Live), or coloured Red.
The plug and socket must be accessible
after installation. Should the mains lead
of the appliance ever require replacing,
we recommend that this is carried out by
a qualified electrician who will replace it
with a lead of the same size and tempera-
ture rating.
Important: - ensure that you route all
mains and electrical cables and flexible
tubing well clear of any adjacent heat
source.
Under no circumstances should the mains
electric cable be allowed to come into con-
tact with hot oven flues or similar surfaces
and keep well clear of any moving parts
that may be in the vicinity of the instal-
lation, such as cooling fans on adjacent
appliances.
Troubleshooting
Before you call Customer Care, please
check the following points:
Burner fails to ignite:
• Check the electricity supply is on.
• Check the fuse.
There is a spark to the burner but it
fails to ignite:
• Check that the flame holes in the flame
spreader are clear of water or deposits.
• Check that the gas supply is turned on.
Smell of gas:
• Check that none of the controls have
inadvertently been turned on. If all the
controls are in the off position, turn off
the gas supply & call Customer Care.
The burner flame appears uneven:
• Check the burner is fitted correctly.
• Check the flame holes in the flame
spreader are clear of water or deposits.
13.302
Advertisement
Table of Contents
