Troubleshooting - Belling IH302T User Manual

Troubleshooting

Failure code
Supply voltage is above the rated
E1
Supply voltage is below the rated
E2
High temperature of ceramic plate
E3
High temperature of ceramic plate
E4
The induction unit may be getting
E5
E6
Ceramic plate temperature sensor
F3/F6 failure- -short circuit. (F3 for 1#, F6
Ceramic plate temperature sensor
F4/F7 failure--open circuit. (F4 for 1#, F7
Ceramic plate temperature sensor
F5/F8 failure—invalid . (F5 for 1#, F8 for
F9/FA failure. (short circuit/open circuit for
FC /FD failure. (short circuit/open circuit for
Problem
voltage.
voltage.
sensor. (1#)
sensor. (2#)
too hot. (1#)
High temperature of IGBT. (2#)
Please request a service visit
for 2#)
for 2#)
2#)
Temperature sensor of the IGBT
1#)
Temperature sensor of the IGBT
2#)
Auto-Recovery
There may have been a power surge or issue
with the power supply. Please contact your
Power on after the power supply is normal
Switch the hob off and allow it to cool down.
When the hob has cooled down, press the
'on/off' key to switch it on again. Be careful
not to heat up empty pans for too long, and
Touch "ON/OFF" button to restart unit.
Switch the hob off and allow it to cool down.
When the hob has cooled down, press the
'on/off' key to switch on again. Start to heat
up a pan of water and listen to hear if the
cooling fan comes on. If the cooling fan does
not come on, or it is noisier than it used to be,
Touch "ON/OFF" button to restart unit.
Check whether the fan runs smoothly;
No Auto-Recovery
Check the connection or replace the ceramic
15
Solution
electricity supplier.
do not allow pans to boil dry.
please request a service visit.
if not , replace the fan.
plate temperature sensor.
Replace the power board.