Belling Hob Users Manual & Installation Handbook page 13

UsInG tHe HoB - InDUctIon
refer to Troubleshooting chart. Also try
switching power off/on to the appliance
to reset the electronics, if the problems
persist call, the customer service hotline
for further assistance.
Hob Status Codes
Max Power Setting reached (Only on 13 Amp
"r"
Indictes no pan or suitable pan on the cook
"U"
Indicates control knob has been left in th on
"o"
"H"
"c" Induction generator over temperature
Induction heater over temperature the product
"C" will automaticlaly reset, indicates a overheated
(8888) In all the Control knobs not turned on when electrical
displays supply is switched on at the cooker socket
Appliance Errors &
Alarms
F / -
F / L
F / E User interface temperature sensor (NTC) error
F / t User interface temperature sensor (NTC) error
F / c
F / H
F / J
F / 0 User interface microcontroller fault
Fault Description
versions)
zone
position.
Residual Heater
pan.
Fault Description
Knob control fault
Knob control limits fault
User interface overtemperature
EEPROM error
Knob control fault
Reduce the power settings on other zones
Ensure the correct pan size is selected and that the pan is suitable for
induction use
Turn the control knob to the off position to reset
"H" will switch off when the glass surface drops below 55
Check the installation and free air flow to the hob are as per the installation
instructions, Normal operation will resume when the appliance is cooled
Allow hob to cool and normal operation will resume
Turns the controls Off before switching the power on to the appliance.
Turn the controls to the off postion and turn the power off and back on to
reset the system
Turn the controls to the off postion and turn the power off and back on to
reset the system
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
Remove hot pans from the display areas and allow the hob to cool
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
Action
o
C