Basic Hob Function; Initial Power Up; To Turn The Hob On/Off; Control Knob Safety Feature “O” - Belling Hob Users Manual & Installation Handbook

UsInG tHe HoB - InDUctIon

BasIc HoB fUnctIon

Initial power up (switching on the
electrical supply to the hob)
After connecting the hob to the mains
electrical supply, all segments of the
displays are illuminated (lit) and a beep
sounds.
The hob then initialises after which, all
displays are deactivated (LEDs go out)
and a beep sounds.
If there is an initialisation problem or if a
control knob is not set to the off position
all displays remain lit, until the initiali-
sation problem is solved or the control
knobs are turned to the off position.
to turn the hob 'on' / 'off'
To turn the hob 'ON', turn the control
knob for the required cook zone clockwise
to set the cook zone to the desired power
setting (1 to 9). The power display will
automatically light up and will "beep".
To turn the hob 'OFF' turn the control
knob anti-clockwise to the 'OFF' position.
When a cook zone is switched off, a beep
sounds and the corresponding display
shows the power level "0". 10 seconds
after switching off, a beep sounds and the
corresponding display is switched off (As
Shown below)
control Knob safety feature "o"
If at any time you see the "o" symbol,
it means that a control knob has been
left on and needs to be turned to the off
position (reset) before the hob can be
used. This is to ensure that power isn't
accidentally switched on to a cook zone
(i.e. turn the control knob off and back on
to continue using).
power Boost
Temporarily boost the power to a cook
zone by approx 25%. All zones can be
boosted for a period of up to 10 minutes.
When booster is selected, a beep sounds
and the corresponding display shows a
"p" symbol.
The booster function only works for a
limited period. After 10 minutes of boost
power level, the cook zone is automati-
cally deactivated, a beep sounds and the
corresponding display shows a "o"
symbol.
The corresponding control knob has to
be turned back to the off position (reset)
before a new cook zone power level can
be set. (i.e. turn the control knob off and
back on to continue using).