Troubleshooting - Belling PBi60R User & Installation Instructions Manual

The hob produces a smell the first few times it is used
• Heat a pan full of water on each zone for half an hour.
Pans make a noise during cooking!!
• This is caused by vibration due to the passage of energy from the hob to the pan.
On a high setting this is quite normal for certain types of saucepan. It will not damage
the hob.
The hob makes a slight clicking sound
• This is caused by the distribution of power between two heating zones on the
same side of the hob.
The top of the hob is always warm (even when not in use)
• The electronic part of the hob, like any other electronic equipment (TV, transformer,
etc), becomes warm.
The fan keeps working for a few minutes after the hob has been turned off
• To cool down the electronics.
The hob won't work. The indicators don't come on
• The electricity supply is not reaching the appliance (faulty supply or connection);
Check the fuses and the cut-out switch.
• The electronic circuit is not working properly;
Call Stoves Customer Support, or your supplier.
When it is turned on, the appliance cuts out
• The hob connection is faulty.
Check the connection and check that the connection complies with the appropriate
standards.
Code
Hob is not working (L) in display
Power boost not working
Control unit cuts off after
ER21
programme setting
ER400
E2 Overheating of induction coil
E8
Fan blocked or faulty

Troubleshooting

Problem
The appliance is hot - Power Boost
is deactivated when the appliance is
hot to protect the electronics & pre-
vent pans overheating
Fan inlets are blocked or faulty fans
Possible Cause
Child lock is activated
Electronics overheating
Pan overheating
19
Solution
Deactivate child lock
Allow appliance to cool, power
boost will be available when the
appliance is cool
Allow appliance to cool
Check mains cable connection &
terminals at the terminal block
are wired correctly
Remove pans & allow to cool
Clean fan inlet at rear/underside
of the appliance