Connect Copy; When Memory Is Full - Lanier 5484 Operator's Manual

What to do if Something Goes Wrong

Connect Copy

Machine Status
You can not use the Punch
function.
The copied images differ.

When Memory is Full

5
If the number of originals exceeds a certain limit, the machine will run out of
memory, for Connect Copy scans in all your originals into memory.
Limitation
If memory is full on either the master unit or sub-unit, Interrupt will not be
available.
Note
If you set the "Memory Full Auto Scan Restart" setting in the User Tools
(Copier/Document Server Features) to "Yes", the memory overflow message
will not be displayed, but originals scanned so far will be copied automatical-
ly. Connect Copy continues scanning and copying until finishing the job.
Please note that copy sets will be printed out separated by scanning at this
time.
Machine Status
The memory is full.
The machine asks you whether you want
to scan the remaining originals.
276
Cause
The sub-unit does not have
the optional punch kit.
The "Original Mode" of the
user tools (Copy Features)
settings are not the same.
The user stamp settings are
not the same on the master
unit and sub-unit.
Action
Press the [Output] key to copy scanned
originals and clear the scanning data.
Press the [Clear] key to clear the scanning
data and not copy.
To continue copying, remove all copies
then press the [Resume] key. To stop copy-
ing, press the [Cancel] key.
Action
Press the [Connect Copy]
key to disconnect, then
start copying.
See P.318 "Adjust Image"
Register the same stamp in
each user stamp.