Interrupt Copy; Original Beeper - Lanier LD235 Copy Reference Manual

Copying
-How to operate
❖ To stop the machine during a multi-
copy run.
Press the {Clear/Stop} key.
❖ To return the machine to the initial
2
condition after copying.
Press the {Clear Modes} key.
❖ When clearing entered values.
Press the {Clear/Stop} key or [Clear]
on the display.
❖ To check the settings.
Press the {Check Modes} key.

Interrupt Copy

Use this function if you want to inter-
rupt a long copy job to make urgently
needed copies.
Limitation
❒ You cannot use the Interrupt Copy
function when fax originals are be-
ing scanned or the scanner func-
tion is being used.
A
Press the {Interrupt} key.
The Interrupt indicator goes on.
When the originals stop scanning
A Remove the originals that were
being copied and place the
originals you want to copy.
B Press the {Start} key.
The machine starts making the
copies.
C When copying is complete, re-
move the originals and copies.
D Press the {Interrupt} key again.
The Interrupt indicator goes off.
18
E When the display prompts you,
place the remaining originals
again before interrupting.
F Press the {Start} key.
Note
❒ The interrupt copy job set-
tings will be restored and the
machine will continue copy-
ing from where it left off.
When the machine keeps
copying
A Place the originals you want to
copy.
B Press the {Start} key.
The machine stops the previous
original job and starts copying
the original.
C When copying is complete, re-
move originals and copies.
D Press the {Interrupt} key again.
The Interrupt indicator goes off.
The interrupt copy job settings
will be restored and the ma-
chine will continue copying
from where it left off.

Original Beeper

The beeper sounds and an error mes-
sage is displayed when you leave
your originals on the exposure glass
after copying.
Note
❒ See p.94 "Tone: Original remains".